Wolf V500 Holden Commodore VN-VS Plug –In, is designed to plug in to the vehicle’s original harness and is suitable for the following models:-
- VN - V6 & V8 Manual & Auto
- VP - V6 & V8 Manual & Auto
- VR - V6 Manual only & V8 Manual
- VS - V8 Manual
It allows for removal of the airflow meter, & using the internal MAP sensor on the Wolf, can be tuned up to 30psi or higher, (45psi can be requested). The adaptor uses all the standard sensors fitted to this vehicle. The external map sensor can be used to keep the “standard look” and the adaptor uses all standard sensors fitted to the vehicle.
Aftermarket manifolds can still be installed for good fuel & idle control. All the gauges and lights on the dashboard remain functional and do not require modification.
Wolf V500 Holden Commodore VN-VS Plug-In harness will allow for factory firing of the injectors, which means that the injectors are wired in batch fire, (two batches of injectors). With its set up as per factory specification, it will fire the DFI ignition without modification and accommodates the torque converter clutch operation allowing more control by the end user.
A/C input gives the ability to step up the idle when the A/C is switched on.
Dual Fuel Maps: separate maps for petrol/race or alternative fuel can be viewed in our software.
The secondary map prevision allows for the setup of launch control and anti lag, which can be done for maximum boost before launching into a race.
Some other functions of the secondary map are “valet mode”, which allows a determined rev limit and tune to be entered. So at the flick of a switch (or turn of a key) this function, limits the power from the engine and stops people giving the vehicle a hard time without your knowledge.
· Tuneabity of 16 load points every 125 rpm both fuel and ignition, makes Wolf V500 Holden VN-VS Plug- In Kit very versatile.
· 12 parameters working just on cold start there is no reason why your vehicles will not turn key & start even if you have big injectors after correct tuning has been achieved.
The Wolf V500 Holden Commodore VN-VS Plug –In will have the connector listed below.
The kit contains:
1 x Wolf V500 ECU
1 x Holden VN-VS Turbo Plug-In Adapter
1 x PC Software Disk
1 x PCSerial Cable
1 x ECU Mounting Velcro
2x Wolf V500 Labels
